UV2D Cabin Module - Usevolt Oy

A cab typically holds dozens of switches, potentiometers and indicator lamps, each of which would otherwise need its own wire running all the way to the control system. UV2D gathers them in one place: the module is mounted in the cab, near the switches, and only the CAN bus and the supply voltage leave for the chassis. The harness gets shorter, there are fewer joints, and a fault is easier to find.

UV2D is part of the Usevolt control system, and like all our controllers it is configured through the UV0D touchscreen display — with no computer and no separate programming tools.

7 digital input pairs, tolerant of 30 V — for switches, toggles and limit switches.
4 analog voltage inputs, 0 – 5 V — for potentiometers and sensors.
4 proportional PWM outputs with current sense, 2300 mA — enough for small valves or indicator lamps.
Sensor supplies built in: VDD at 700 mA and 5 V at 300 mA.
Aluminium enclosure, IP67 — it takes the cab’s temperatures and its dust.

Technical specifications

Supply voltage	8 – 30 V DC
Protection	Over-voltage and reverse-voltage. An external 20 A fuse is required.
Current consumption	Logic 40 mA
Outputs	4 x proportional high-side PWM output with current sense
Output max current	2300 mA
Inputs	4 x analog voltage input, 0 – 5 V 7 x digital input pair, 30 V tolerant
Sensor supplies	VDD 700 mA and 5 V 300 mA
Communications	1 x CAN bus 2.0B, CANopen protocol
Connector	Superseal 4-1437290-0, golden contacts 3-1447221-4 (34-pin)
Microcontroller	32-bit ARM Cortex-M3
Memory	256 kB application flash, 36 kB RAM
IP rating	IP67
Material	Aluminium
Weight	320 g
Storage temperature	-30 … +80 °C
Configuring	Through the UV0D display

Connector pin-out

The UV2D 34-pin connector pin-out.

Downloads

Datasheet (PDF)
Dimensions (PDF)

To ask about UV2D and fitting it to your machine, see the contact page.